Guides Mazda MX-5 ND

Mazda MX-5 / MX-5 RF ND exhaust: which one to choose?

By 10 dk okuma

Mazda MX-5 / MX-5 RF ND exhaust: which one to choose?

The right MX-5 ND exhaust, for the 2.0-litre engine in the roadster as in the RF, is the Rog line: it gives the small naturally aspirated four-cylinder of the Mazda a lively timbre that it keeps to itself as standard. It is made to your VIN, in 304 stainless steel or titanium, with valves that let you choose between the weekend outing and the quiet journey. This guide presents the car, its engine and our recommended configurations.

Your valved exhaust for Mazda MX-5 / MX-5 RF ND is configured from your VIN, and the Mazda MX-5 ND Valved Exhaust page brings together every system we make for this generation.

Brushed titanium valved exhaust for Mazda MX-5 / MX-5 RF ND 2.0 Skyactiv-G (2016-2021), pure sound without resonator, Rog gloss black tips - RogMotorsportMazda MX-5 / MX-5 RF ND 2.0 Skyactiv-G Klapeli Egzoz Sistemi (2016-2021)Başlangıç fiyatı 2 080 € · free delivery · 20 working days View
Rog valved exhaust system for Mazda MX-5 / MX-5 RF ND Skyactiv-G

Your Rog exhaust for the Mazda MX-5 / MX-5 RF ND Skyactiv-G

Configure my exhaust

The short answer.

Vehicle
Mazda MX-5 ND and MX-5 RF with the 2.0-litre engine, from 2016 to 2021
Engine
2.0 Skyactiv-G: naturally aspirated four-cylinder, 160 or 184 hp
Exhaust
Cat-back with valves, from the manifold to the outlets
Sound
A lively, mechanical timbre, especially with the roof down
Material
304 stainless steel, or brushed, gold or purple titanium
Manifolds
200-cell or 100-cell manifolds, or catalyst-free, as an option
Valves
Fitted to the exhaust, operated by the Rog remote
Lead time and warranty
20 working days to make, free delivery, 3-year warranty

Your vehicle.

All our exhausts for this generation, version by version, are brought together on one page: Mazda MX-5 ND Valved Exhaust.

The fourth-generation MX-5, known as the ND, carried on a tradition of more than a quarter of a century: a small, light, rear-drive roadster that you drive for the pleasure of the road more than for speed. Here is what you need to know about the car, its 2.0-litre and its voice before choosing an exhaust for it.

Model
Mazda MX-5 ND, roadster and RF
Years
From 2016 to 2021 for this product page
Body styles
Roadster with a soft top and RF with a retractable hard top
Engine
2.0 Skyactiv-G: 1,998 cc naturally aspirated four-cylinder
Factory output
160 hp and 200 Nm, then 184 hp and 205 Nm depending on the model year
Gearbox
Six-speed manual, most often
Drivetrain
Rear-wheel drive, with a limited-slip differential

The fourth generation of the Mazda roadster

Mazda unveiled the MX-5 ND in 2015. After three generations, the brand returned to the original recipe: a compact, light car with a front engine and rear-wheel drive, designed around the feel of driving. The house principle is known as Jinba Ittai, which roughly means horse and rider as one.

This philosophy explains why the ND does not try to win comparisons of figures, nor to impress with its times on paper. It relies on its low weight, its low centre of gravity and an engine that loves to climb through the revs.

Roadster or RF

Two body styles sit side by side in the range. The soft-top roadster is the more classic version, the one where the driver is closest to the road and the noises around it. The RF, which arrived in 2017, replaces the soft top with a retractable hard top with a fastback line.

The chassis, the engine and the exhaust are the same on both, which simplifies the choice for owners: the RF is only slightly taller. This line therefore suits both; the VIN specifies the version before we start production of your exhaust, whatever the body style.

160 hp, then 184 hp

The 2.0 Skyactiv-G developed 160 hp at 6,000 rpm and 200 Nm at 4,600 rpm in its first form. An update then went through the range from 2018: power rose to 184 hp with 205 Nm.

The bars below use the Rog product page's values unchanged for each of the two versions: factory, then what a full ECU remap allows.

Factory 160 hp version

Power

Factory160 hp
Stage 2184 hp

Torque

Factory200 Nm
Stage 2221 Nm

184 hp version from the factory

Power

Factory184 hp
Stage 2205 hp

Torque

Factory205 Nm
Stage 2230 Nm

Stage 2: published figures with the manifolds and an ECU remap carried out by a tuner.

A naturally aspirated four-cylinder

The engine is a 1,998 cc inline four-cylinder, without a turbo, with a bore of 83.5 mm and a stroke of 91.2 mm and a compression ratio of 13 to 1, high for a naturally aspirated engine. It revs willingly into the high range and reacts instantly to the pedal.

This architecture makes all the difference compared with boosted engines: no turbo to smother the voice, but no generous torque at low revs either. The sound is that of an engine that breathes freely, and it belongs to the car as much as to the exhaust.

And the 1.5-litre in the range?

The ND also exists with a 131 hp 1.5-litre, lighter and gentler. This product page does not cover it. If your MX-5 has this engine, the VIN lets us check what suits it before we make anything.

The 2.0-litre is recognised by its broader torque and its more sustained climb through the revs. It powers the roadster and the RF alike. It is the one the Rog exhaust described here is for.

Rear-wheel drive and differential

The power goes to the rear wheels, most often through a six-speed manual gearbox. The 2.0-litre version gets a limited-slip differential, which distributes traction out of corners.

The car remains very light for its segment. Every kilo added or removed at the rear is felt, and that is one of the reasons titanium interests MX-5 owners so much.

What the factory exhaust lets you hear

With its factory exhaust, the small engine stays in the background: with the roof down, you mainly hear the intake and a mechanical breath, more than a true exhaust note. On our scale of 0 to 10, the factory exhaust sits at around 3.

It is also why the sound is the first thing MX-5 enthusiasts try to improve: on a roadster, noise is part of the pleasure, far more than on a closed coupé.

What the Rog exhaust changes

With the valves open, the MX-5 gains a lively, mechanical timbre, which fills out as the needle climbs, and a few light pops when you lift off the accelerator. The Rog cat-back alone, valves open, reaches 7 on our scale, against 3 for the factory exhaust.

With the valves closed, the roadster regains a reasonable volume. At a steady speed, the exhaust does not drone: you can drive on the motorway with the roof down without getting tired, then open the valves when the road becomes interesting.

The Rog remote

On the product page, the valves are fitted to the exhaust and operated by the Rog remote, whose small control unit slips into the boot. Open, the valves stay open; closed, they stay closed. One gesture is enough to change character.

Your garage connects the exhaust with clamps and gaskets, without welding or cutting. The control is independent of the gearbox and the engine, and adds no connection to the on-board electronics.

Stainless steel, titanium, straight pipe or resonator

304 stainless steel gives the 2.0-litre a full, round sound, and stands up to winter salt. Titanium, around 40% lighter for the same design, saves weight at the rear and brings a brighter note at high revs; it comes in brushed, gold and purple.

The character is chosen at the same price: the straight pipe delivers the engine's raw sound, while the resonator lends it a rounder, slightly softer voice, which suits long roads with the roof down.

The tips

The product page offers Rog tips in chrome, gloss black or blued titanium, or the no-tips option to keep the original outlets. This choice changes the car's rear look, not its sound.

On a small roadster, a restrained finish is often enough, because the car is low and compact and the outlets remain little visible from the side; blued titanium, on the other hand, gives the RF a sportier accent.

The manifolds as an option

Under the name "Manifold", the product page offers the manifolds, with the factory catalytic converter built in. On a naturally aspirated engine, their geometry affects cylinder filling at high revs, and the gain remains modest: only a few percent, with an ECU remap.

The 200-cell version keeps the emissions control and suits a roadster used in all seasons. The 100-cell version depends on the car and the regulations of the country where it is driven, and the catalyst-free version gives the freest sound.

Configure your exhaust.

How the exhaust is put together

On the MX-5 ND, the Rog exhaust starts at the connection under the floor and reaches the rear outlets: pipes, silencers and valves. The manifolds, with their catalytic converter, are offered as an option under the name "Manifold".

Each choice explained in detail, from sound to material: How to configure your exhaust.

Your exhaust for the MX-5 ND 2.0

On the product page, you choose 304 stainless steel or brushed, gold or purple titanium, then, if you wish, manifolds with 200 cells, 100 cells or catalyst-free. The valves are operated by the Rog remote, and Rog tips in chrome, gloss black or blued titanium finish off the exhaust.

The price of each configuration is shown on the product page, in your currency.

Your exhaust2 080 €
Continue with this configuration

Your choices carry over to the product page: only the finishes, your VIN and the cart remain.

Three recommended configurations.

  • Everyday roadster

    • Stainless steel
    • No manifold
    • Rog remote
    • Chrome tips

    For an MX-5 used every day: the manifolds stay the factory ones, and you open the valves with the roof down or folded.

    View this configuration
  • Fine roads

    • Titanium
    • 200-cell manifolds
    • Rog remote
    • Blued titanium tips

    For a roadster taken out at the weekend: 200-cell manifolds, which keep the emissions control, and titanium to keep the rear light.

    View this configuration
  • Track days

    • Titanium
    • Catalyst-free
    • Rog remote
    • No tip

    For an MX-5 used on track days: catalyst-free manifolds and valves open throughout the session.

    View this configuration

From order to fitting.

VIN, manufacture, delivery, fitting and warranty, step by step

Questions.

Can my MX-5 ND with the 1.5-litre engine take this exhaust?

No. The product page is written for the 2.0-litre of the 2016 to 2021 years; the 1.5-litre is excluded. In doubt about your car? The VIN requested when you order settles the question before we make anything.

Does the RF need a different exhaust?

No. The roadster and the RF share the chassis, the 2.0-litre and the fitting with clamps and gaskets. The VIN simply checks which power and which model year you have.

My MX-5 has 160 hp, a friend's has 184 hp: is the exhaust the same?

The product page covers both power outputs of the 2.0-litre. The VIN shows which one is yours, and we reply to you in writing before starting production.

How does it sound compared with the MX-5's factory exhaust?

On our scale of 0 to 10, the factory exhaust sits at around 3. With the valves open, the Rog exhaust alone rises to 7, and the optional manifolds go further. With the valves closed, the roadster stays close to its original volume.

With the roof down, does the exhaust become tiring on the motorway?

No, with the valves closed: the engine stays composed at a steady speed. You open as soon as the road empties, where the car's character comes out, in one gesture, with the Rog remote.

Are the manifolds worth it on a naturally aspirated engine?

The gain remains modest, a few percent with an ECU remap: here it is the voice you come for, more than the power. Without a remap, they change only the sound.

Mazda MX-5 / MX-5 RF ND 2.0 Skyactiv-G Klapeli Egzoz Sistemi (2016-2021)

Başlangıç fiyatı 2 080 € · 3-year warranty

Configure my exhaust

A question about your MX-5 ND?

Put it to the Rog Advisor or write to us: we reply in writing, within 24 hours.

Further reading.