Valved Exhaust System for Ferrari 360 Modena / 360 Spider V8 3.6 (2003-2005)
Configuration
Ferrari 360 Modena / 360 Spider V8 3.6 Valved Exhaust System (2003-2005)
Valves
Operated by remote control, factory-paired.
Estimated at 0.50 m from the outlet, 45°, 2,000 rpm with a warm engine. Allow ± 2 dB depending on the engine and measuring point. A 3 dB difference is audible in a direct comparison; 10 dB sounds roughly twice as loud.
Configuration guide
Sound intensity with the valves open, on a scale of 0 to 10.
| Configuration | Intensity |
|---|---|
| Decat front pipes + Rog cat-back | 10/10 |
| 100-cell sports catalytic converter + Rog cat-back | 9/10 |
| 200-cell sports catalytic converter + Rog cat-back | 8/10 |
| Rog cat-back only, factory catalytic converter retained | 7/10 |
| Factory exhaust, for comparison | 3/10 |
The Ferrari 360 Modena / 360 Spider exhaust in detail.
With no turbo to mask anything, the 360’s 3.6-litre V8 owes its voice to itself alone: a flat crankshaft, revs climbing to around 8,500 rpm, a high-pitched scream that became Maranello’s signature. The factory exhaust, designed to the standards of its time, still holds back a large part of it. With the valves open, the valved Rog cat-back lets the high harmonics through and turns every gear taken to the limit into a small event; with the valves closed, the berlinetta returns to a level close to stock for early-morning departures.
This system is designed for the Ferrari 360 with the V8 3.6, for the 2003 to 2005 model years covered by our page, the first Ferrari with an all-aluminum structure: 400 hp and 373 Nm from the factory. The more recent 430 Scuderia has its own page. The 360 Spider takes the same system as the Modena; for an older car, send us your VIN: we check before starting manufacturing.
Under the 360’s aluminum body, the exhaust is attached with clamps and gaskets, without welding or cutting, in about two hours for a workshop equipped with a lift. For control, the exhaust uses the factory control if your 360 has factory valves; otherwise the Rog remote, a box housed in the trunk and two buttons, opens and closes on demand.
On the 360, the front section corresponds to the pipes placed just after the manifolds, with the catalytic converter; the page offers them under the “Manifold” option. On a naturally aspirated engine, their design affects cylinder filling at high revs: the gain is real but modest, 3 to 8%, and only appears with an ECU remap, while the 200-cell version keeps emissions control. That leaves the choice of material, which matters on a berlinetta of this age: robust 304 stainless steel, or titanium around 40% lighter for the same design and finished in brushed, gold or purple.
Ferrari 360 Modena / Spider 3.6 V8 exhaust specifications.
| System type | Valved cat-back (valve exhaust), built to your VIN |
|---|---|
| Vehicles | Ferrari 360 Modena and 360 Spider, V8 3.6 |
| Engine | 3.6-litre naturally aspirated flat-plane-crank V8, 400 hp and 373 Nm |
| Years | 2003-2005 |
| Materials and finishes | 304 stainless steel or titanium; titanium in brushed, gold or purple |
| Valves | Factory valve control if the car has it, otherwise the Rog remote |
| Front section (option) | Front pipes with 200-cell or 100-cell catalytic converters, or decat |
| Fitting | Clamps and gaskets, no welding, about 2 hours |
| Manufacturing and delivery | Made to order, 20 working days, free delivery |
| Warranty | 3 years, parts and workmanship |
Questions about the Ferrari 360 Modena / Spider 3.6 V8 exhaust.
My 360 Modena predates 2003: can the system suit it?
Our page covers the 2003 to 2005 model years, with 400 hp. For an older car, nothing is stated in advance: the VIN lets us confirm compatibility before any manufacturing.
Once the exhaust is in place, does the 360 need a session on the remapping dyno?
Not for the cat-back, which leaves the ECU as it is. With the sports front pipes, it is a different story: an approved tuner can then aim for the 445 hp and 420 Nm published for Stage 2 on the 360, 45 hp more than the factory 400 hp.
How should a modified Ferrari 360 be presented at vehicle inspection?
Close the valves before entering the testing centre: the 360 returns to a sound level close to stock. As long as the original front pipes or their 200-cell version stay in place, the catalytic converter does its job. A set of 100-cell pipes will be accepted or not depending on the car and the rules in your country, and a decat 360 is reserved for track use.
Are the front pipes worth it on the 360’s naturally aspirated V8?
For the sound, the cat-back already does most of the work. The sports front pipes are aimed at those who remap: on this non-turbo V8, expect a modest gain, 3 to 8% depending on the car, rather than a transformation in performance.
Does the 360 Spider take the same system as the Modena?
Yes. The 360 Modena and the 360 Spider take the same Rog system: same chassis, same 3.6-litre V8, same clamp-and-gasket fitting. Your VIN is only used to confirm the version and model year before manufacturing.
Does a valved 360 drone on the highway?
No, as long as the valves stay closed: the flow then passes through the muffler chambers, designed for cruising, and the 360’s V8 goes unnoticed at 130 km/h. The valves open when you decide, leaving the toll booth or on a mountain pass.
Rog expert guide
Ferrari 360 Modena / 360 Spider: bringing out the naturally aspirated V8, the complete guide
The 360 Modena is officially a classic: the first all-aluminum Ferrari, a naturally aspirated V8 revving to 8,500 rpm, and auction prices that keep climbing. A quality exhaust is the modification that transforms it, while respecting its status. Here you...
In detail
Rog Advisor
A question about this exhaust?
Fitment, sound, catalyst, valves, delivery: the answer comes straight away, with your configuration in context.
The Rog Advisor is an automated assistant trained on our product pages and answers. For an important decision, write to us: we confirm by e-mail.
Unsure about your configuration? Talk to us before you order. We know your car. Write to us at contact@rogmotorsport.com: we reply in writing, in English, within 24 hours. Email us
Your country
Rog in Canada.
Inspections in Canada
A Rog cat-back leaves your factory catalytic converter, oxygen sensors and OBD untouched, and valves closed, your car sounds very close to stock at a safety inspection. Sport cats follow your province's rules, the catless version is for the track only, and your province decides.
On the road
Valves closed around town, your car sounds very close to stock, and you open them whenever you like.
Your documents
Each system is built from the VIN on your vehicle registration, and we send its technical documentation free on request, for an inspection or for your insurer.
Your insurance
Tell your insurer before installation: our free technical documentation makes it easy.
Reviews imported from our previous system and translated from French; verified purchases carry the badge.
Rog presentation film: choosing your vehicle, Standard or Equal Length design, stainless steel or titanium, Z-Pipe, controlled valves, titanium and tip finishes, and support from choosing your configuration through to shipping.
THE Rog CRAFT
Our process.
From the first bend to the last check. The same care at every step.
-
Design
Designed for your vehicle.
Geometry matched to your model, carefully studied bends and precise mounting points. Everything starts with accurate design.
-
Manufacture
Crafted with precision.
Tube bending, part fitting and TIG welding: every joint receives the same care.
-
Finishing
Material, elevated.
The finish reveals the character of the metal. Stainless steel or titanium, depending on the options available for your vehicle.
-
Assembly
Every part in its place.
Components are assembled and adjusted. On valved systems, the mechanism is fitted, set up and tested.
-
Inspection
Check. Then approve.
Geometry, welds, connections and gas flow: the key points are inspected before shipping.
-
Shipping
Ready to join you.
Reinforced packaging protects your exhaust in transit. The final step before giving your vehicle a new voice.
Customer builds
Your videos & photos
The Rog lines fitted on our customers' vehicles, in real conditions.
- Builds
- 500+
- Brands
- 28
- Satisfaction
- 4,9
The journal
News & advice
Best valved exhaust for the Audi RS3 8Y
Which valved exhaust for an Audi RS3 8Y? The options compared (sound, material, valves) and the Rog system made to...
Read the articleBest valved exhaust for the Mercedes-AMG A45 / A45 S W177
Which valved exhaust for a Mercedes-AMG A45 or A45 S W177? The options compared (sound, material, valves) and the Rog...
Read the articleBest valved exhaust for the BMW M2 G87
Which valved exhaust for a BMW M2 G87? The options compared (sound, material, valves) and the Rog system made to...
Read the articleExhaust rules: what changes in 2026 and 2027 (Euro 7, noise cameras, MOT)
Euro 7, new-car noise, noise cameras, MOT and vehicle inspection, and models: what really changes in 2026 and 2027 for...
Read the articleChanging your exhaust: what inspections and approvals cost in 9 countries
What the periodic inspection and the check of a modification cost after changing your exhaust, in 9 European countries: official...
Read the articleIs a cat-back exhaust legal in Ontario? Canada, province by province.
The sound you choose, and a quiet car when it matters: what you get with a Rog valved exhaust in...
Read the articleNo article matches this search.
All articles