









Valved Sports Exhaust System Kit for Toyota GR86 ZN8 FA24 2.4 (2022+)
Configuration
Toyota GR86 ZN8 Valved Exhaust FA24 2.4 (2022+)
Valves
Operated by remote control, factory-paired.
Estimated at 0.50 m from the outlet, 45°, 2,000 rpm with a warm engine. Allow ± 2 dB depending on the engine and measuring point. A 3 dB difference is audible in a direct comparison; 10 dB sounds roughly twice as loud.
Configuration guide
Sound intensity ratings are not yet available for this model.
The Toyota GR86 ZN8 2.4 exhaust in detail.
Valved exhaust for Toyota GR86 ZN8 2.4: this Toyota GR86 ZN8 exhaust system is made to order from your VIN. The second generation of the line, the GR86 ZN8 arrived in 2022 with a bigger engine and the same recipe: rear-wheel drive, a boxer sitting very low, a centre of gravity close to the ground, a balance praised by the whole motoring press. Its naturally aspirated 2.4-litre FA24 produces 234 hp and 250 Nm in European form, enough to have fun without ever overwhelming the rest, so the sound counts double, while the factory system remains very discreet.
No turbo here: all the character plays out in the revs. With the valves open, the Rog valved cat-back lets the boxer sing at full voice, louder and louder as the needle climbs towards the red line, with sharp crackles when you lift off; once they are closed, the GR86 becomes as discreet as it was when it left the factory. This system is designed for the GR86 ZN8 built since 2022; the GT86 ZN6 that preceded it has its own, and your VIN is checked before manufacturing.
Allow about two hours for fitting, with clamps and gaskets, without welding. The valves follow the factory control when the car has one; otherwise, the two-button Rog remote operates them.
On the GR86, the Rog system works without an ECU remap: the benefit lies mainly in sound and breathing, which is exactly the point on a car built for sensations. Two black round tips finish the system; for the rest, you choose 304 stainless steel or titanium, around 40% lighter for the same design, which matters on a GR86 whose whole philosophy rests on lightness.
The sound, configuration by configuration
On a scale of 0 to 10, a stock Toyota GR86 ZN8 sits around 3. With the Rog system and the valves open, it goes to around 7: already night and day.
Made from your VIN, fitted by your garage
Every system is made from your VIN and checked before production: it fits your Toyota GR86 ZN8 perfectly, with no welding, on the original mounting points. Fitting is done by the garage of your choice; after ordering, write to us with your order number and we will suggest three trusted garages near you. Allow 20 working days from order confirmation to delivery, with free shipping.
Toyota GR86 ZN8 2.4 exhaust specifications.
| System type | Valved cat-back (valve exhaust), built to your VIN |
|---|---|
| Vehicle and chassis code | Toyota GR86 (also written GR 86), second-generation ZN8, same system as the Subaru BRZ ZD8 2.4 |
| Engine | FA24, naturally aspirated 2.4-litre flat-four, 234 hp and 250 Nm |
| Years | Since 2022 |
| Materials and finishes | 304 stainless steel or titanium; titanium in brushed, gold or purple |
| Valves | Factory valve control if the car has it, otherwise the Rog remote |
| Fitting | Clamps and gaskets, no welding, about 2 hours |
| Manufacturing and delivery | Made to order, 20 working days, free delivery |
| Warranty | 3 years, parts and workmanship |
Questions about the Toyota GR86 ZN8 2.4 exhaust.
GR86 ZN8 or Subaru BRZ ZD8: does the Rog system change from one twin to the other?
No. Toyota and Subaru developed this second generation together: the GR86 comes out of the same factory as the BRZ ZD8, with the same 2.4-litre FA24 boxer and a Subaru VIN starting with JF1. Same Rog system, same price, only the reference changes.
Own an older GT86 ZN6: does this GR86 ZN8 system apply to you?
No, the first generation, the GT86 ZN6, also called the Toyota 86 or Scion FR-S, has its own system. This one is reserved for the GR86 ZN8 built since 2022, with a VIN check before manufacturing.
What power gain can you expect on a GR86 ZN8 fitted with this system?
Nothing notable on paper: the cat-back acts on the voice and the breathing, and takes off a little weight. On a 234 hp naturally aspirated boxer, that is by design: the GR86 is driven for sensations, and the Rog system adds a lot of them.
On the day of the vehicle inspection, what should you do with a modified GR86 ZN8?
Simply close the valves before the appointment: the GR86 then regains the voice and the discretion of the stock car, and that is the position in which it goes through the vehicle inspection.
Can a modified GR86 ZN8 stay discreet in town as well as on the motorway?
Yes: with the valves closed, the GR86 regains its factory discretion, and our systems are designed to avoid drone on the motorway. You open them when the road starts to wind, via the factory control or the Rog remote.
Toyota GR86 ZN8 2.4: straight pipe or resonator?
On this model, two characters at the same price: the straight pipe for the raw sound of your engine, unfiltered, or the resonator for a rounder and slightly softer voice. Either way, the exhaust stays fully sporty. Learn more: Exhaust resonator: what does it do? Straight pipe or resonator, which sound to choose.
Toyota GR86 ZN8: factory valves or Rog valves?
If your Toyota GR86 ZN8 has factory valves, you can choose to keep them: the system arrives with their mounts in place, you refit them and they work as before, through the drive modes. With Rog valves, the system comes already fitted to the exhaust and is controlled by remote; open or closed, the valves stay in the chosen position. The small control unit goes in the boot or at the front and connects to the cigarette lighter socket, to ring terminals or directly to the battery: everything is pre-wired, nothing to cut, 10 to 15 minutes on average. The remote is shipped without a battery because of carrier rules: remember to fit one.
Rog expert guide
Subaru BRZ ZD8 / Toyota GR86 ZN8 exhaust: which one to choose?
The BRZ ZD8 fixes everything people criticised about the first one: 235 hp, mid-range torque and the same magical chassis. That leaves the factory sound, still far too discreet for such a playful car. Here you will find everything that...
In detail
Rog Advisor
A question about this exhaust?
Fitment, sound, catalyst, valves, delivery: the answer comes straight away, with your configuration in context.
The Rog Advisor is an automated assistant trained on our product pages and answers. For an important decision, write to us: we confirm by e-mail.
Unsure about your configuration? Talk to us before you order. We know your car. Write to us at contact@rogmotorsport.com: we reply in writing, in English, within 24 hours. Email us
Reviews imported from our previous system and translated from French; verified purchases carry the badge.
Rog presentation film: choosing your vehicle, Standard or Equal Length design, stainless steel or titanium, Z-Pipe, controlled valves, titanium and tip finishes, and support from choosing your configuration through to shipping.
THE Rog CRAFT
Our process.
From the first bend to the last check. The same care at every step.
-
Design
Designed for your vehicle.
Geometry matched to your model, carefully studied bends and precise mounting points. Everything starts with accurate design.
-
Manufacture
Crafted with precision.
Tube bending, part fitting and TIG welding: every joint receives the same care.
-
Finishing
Material, elevated.
The finish reveals the character of the metal. Stainless steel or titanium, depending on the options available for your vehicle.
-
Assembly
Every part in its place.
Components are assembled and adjusted. On valved systems, the mechanism is fitted, set up and tested.
-
Inspection
Check. Then approve.
Geometry, welds, connections and gas flow: the key points are inspected before shipping.
-
Shipping
Ready to join you.
Reinforced packaging protects your exhaust in transit. The final step before giving your vehicle a new voice.
Customer builds
Your videos & photos
The Rog lines fitted on our customers' vehicles, in real conditions.
- Builds
- 500+
- Brands
- 28
- Satisfaction
- 4,9
The journal
News & advice
From order to fitting of your Rog exhaust
Your Rog exhaust is made for your car, to its VIN. Here is what happens between your order and the...
Read the articleHow to configure your Rog exhaust
A Rog exhaust is configured in five decisions, always in the same order: sound, material, front section, valves, then looks....
Read the articleValved exhaust comparison for the Audi RS3 8Y
Which valved exhaust for an Audi RS3 8Y? The options compared (sound, material, valves) and the Rog system made to...
Read the articleValved exhaust comparison for the Mercedes A45 W177
Which valved exhaust for a Mercedes-AMG A45 or A45 S W177? The options compared (sound, material, valves) and the Rog...
Read the articleValved exhaust comparison for the BMW M2 G87
Which valved exhaust for a BMW M2 G87? The options compared (sound, material, valves) and the Rog system made to...
Read the articleExhaust rules: what changes in 2026 and 2027 (Euro 7, noise cameras, MOT)
Euro 7, new-car noise, noise cameras, MOT and vehicle inspection, and models: what really changes in 2026 and 2027 for...
Read the articleChanging your exhaust: what inspections and approvals cost in 9 countries
What the periodic inspection and the check of a modification cost after changing your exhaust, in 9 European countries: official...
Read the articleIs a cat-back exhaust legal in Ireland? What the NCT checks.
A cat-back leaves your factory cat, sensors and OBD as they are; valves closed, very close to stock, valves open,...
Read the articleNo article matches this search.
All articles
