Valved Exhaust System for Audi RS6 Avant C7 / C7.5 4.0 TFSI V8 (2013-2018)
Configuration
Audi RS6 Avant C7 / C7.5 4.0 TFSI V8 Valved Exhaust System (2013-2018)
Valves
Operated by remote control, factory-paired.
Estimated at 0.50 m from the outlet, 45°, 2,000 rpm with a warm engine. Allow ± 2 dB depending on the engine and measuring point. A 3 dB difference is audible in a direct comparison; 10 dB sounds roughly twice as loud.
Configuration guide
Sound intensity with the valves open, on a scale of 0 to 10.
| Configuration | Intensity |
|---|---|
| Decat downpipe + Rog cat-back | 10/10 |
| 100-cell sports catalytic converter + Rog cat-back | 9/10 |
| 200-cell sports catalytic converter + Rog cat-back | 8/10 |
| Rog cat-back only, factory catalytic converter retained | 7/10 |
| Factory exhaust, for comparison | 3/10 |
AudiA6 / A7 / S6 / S7 / RS6 / RS7 C7
Which valved exhaust for an Audi RS6 Avant C7 or C7.5?
The Rog system for the Audi RS6 Avant C7 and C7.5 is a valved cat-back exhaust in 304 stainless steel or titanium, built to your VIN for the 560 hp twin-turbo V8 4.0 TFSI, or 605 hp in Performance form. Valves open, the V8, with its turbos inside the vee, finally rumbles at idle and revs with authority; closed, the estate turns discreet again for the family.
Sound, options and fitting in detail: our Audi RS6 Avant C7 guide.
The fastest estate of its generation is on this page: the RS6 Avant C7 and C7.5, from 2013 to 2018, with its 560 hp twin-turbo 4.0 TFSI V8, or 605 hp in Performance form, with 700 Nm. The RS7 Sportback C7 shares this V8, but not the rear section: it has its own page, and your VIN is checked before manufacturing. The RS6 and RS7 C8 have their own system, as do the S6 and S7 C7.
Despite these figures, the factory RS6 stays muted: turbos inside the V and silencers designed for cruising keep the V8 on a leash. With the valves open, our valved cat-back removes these restrictions: a deep rumble at idle, a commanding climb, crackles when you lift off. With the valves closed, the estate becomes discreet again for long family journeys.
Among the options, on this twin-turbo the “Manifold” option corresponds to the downpipes, which leave the turbos and carry the catalytic converters. On an estate that also carries the family, the 200-cell versions keep emissions control; the 100-cell versions are accepted or not depending on the vehicle and your country’s rules, and the decat versions are reserved for track use. Without an ECU remap, the V8 gains no horsepower, just sound and a little weight saving.
A lift, clamps, gaskets: the exhaust fits without welding in about two hours. The drive modes continue to control the factory valves; otherwise, the Rog remote opens and closes them at the push of a button. 304 stainless steel gives a full voice, titanium weighs around 40% less and can be chosen in brushed, gold or purple.
Audi RS6 Avant C7 / C7.5 4.0 TFSI V8 exhaust specifications.
| System type | Valved cat-back (valve exhaust), built to your VIN |
|---|---|
| Vehicle and chassis code | Audi RS6 Avant C7 and C7.5, including Performance (RS7 Sportback C7: separate page) |
| Engine | 4.0 TFSI, twin-turbo V8, 560 to 605 hp and 700 Nm depending on the version |
| Power in kW | 412 to 445 kW |
| Years | 2013-2018 |
| Materials and finishes | 304 stainless steel or titanium; titanium in brushed, gold or purple |
| Valves | Factory control through the drive modes, or the Rog remote |
| Front section (option) | Downpipes with 200-cell or 100-cell catalytic converters, or decat |
| Fitting | Clamps and gaskets, no welding, about 2 hours |
| Manufacturing and delivery | Made to order, 20 working days from confirmation to delivery, free delivery |
| Warranty | 3 years, parts and workmanship |
Questions about the Audi RS6 Avant C7 / C7.5 4.0 TFSI V8 exhaust.
I drive an RS7 C7: can I order the RS6 Avant system?
No, not this one: the RS7 Sportback C7 has the same 4.0 TFSI V8, but its rear section is specific to its body style. It has its own page, Audi RS7 4G, with the same clamp-and-gasket fitting; your VIN confirms the system before manufacturing.
Remapped RS6 C7 Performance: which figures are published?
The cat-back alone leaves the V8 with its factory tune. By adding the downpipes and a suitable map, the page lists 710 hp and 900 Nm for the 605 hp Performance, and 700 hp and 880 Nm for the 560 hp version.
Vehicle inspection: can a valved RS6 C7 be presented?
Yes, with the valves closed, with a V8 close to its factory level. Cat-back only or 200-cell downpipes: the RS6 keeps all its emissions control. If you opt for the 100-cell, acceptance depends on the vehicle and your country’s rules; in decat form, the RS6 is a track estate.
What is the manufacturing lead time for an RS6 Avant C7 system?
Each system is produced for a specific VIN; allow 20 working days from confirmation to delivery, with no shipping cost. Fitting then takes about two hours at the garage of your choice.
Audi RS6 Avant C7 / C7.5 4.0 TFSI V8: Does a valved exhaust system drone?
No. With the valves closed, the gases flow through the whole rear silencer and the cabin stays calm at a steady speed. Our Rog exhausts are designed to avoid drone. Learn more: Why our systems stay calm on the motorway.
Audi RS6 Avant C7 / C7.5 4.0 TFSI V8: straight pipe or resonator?
On this model, two characters at the same price: the straight pipe for the raw sound of your engine, unfiltered, or the resonator for a rounder and slightly softer voice. Either way, the exhaust stays fully sporty. Learn more: Exhaust resonator: what does it do? Straight pipe or resonator, which sound to choose.
Rog expert guide
Audi RS6 C7: giving the 4.0 TFSI V8 its voice back, the complete guide
For many, the RS6 C7 is still the ultimate RS6: the 4.0 TFSI without an OPF, and a price-to-performance ratio that has become unbeatable on the used market. Its factory exhaust is adequate at best: the V8 has far more...
In detail
Rog Advisor
A question about this exhaust?
Fitment, sound, catalyst, valves, delivery: the answer comes straight away, with your configuration in context.
The Rog Advisor is an automated assistant trained on our product pages and answers. For an important decision, write to us: we confirm by e-mail.
Unsure about your configuration? Talk to us before you order. We know your car. Write to us at contact@rogmotorsport.com: we reply in writing, in English, within 24 hours. Email us
Reviews imported from our previous system and translated from French; verified purchases carry the badge.
Rog presentation film: choosing your vehicle, Standard or Equal Length design, stainless steel or titanium, Z-Pipe, controlled valves, titanium and tip finishes, and support from choosing your configuration through to shipping.
THE Rog CRAFT
Our process.
From the first bend to the last check. The same care at every step.
-
Design
Designed for your vehicle.
Geometry matched to your model, carefully studied bends and precise mounting points. Everything starts with accurate design.
-
Manufacture
Crafted with precision.
Tube bending, part fitting and TIG welding: every joint receives the same care.
-
Finishing
Material, elevated.
The finish reveals the character of the metal. Stainless steel or titanium, depending on the options available for your vehicle.
-
Assembly
Every part in its place.
Components are assembled and adjusted. On valved systems, the mechanism is fitted, set up and tested.
-
Inspection
Check. Then approve.
Geometry, welds, connections and gas flow: the key points are inspected before shipping.
-
Shipping
Ready to join you.
Reinforced packaging protects your exhaust in transit. The final step before giving your vehicle a new voice.
Customer builds
Your videos & photos
The Rog lines fitted on our customers' vehicles, in real conditions.
- Builds
- 500+
- Brands
- 28
- Satisfaction
- 4,9
The journal
News & advice
Best valved exhaust for the Audi RS3 8Y
Which valved exhaust for an Audi RS3 8Y? The options compared (sound, material, valves) and the Rog system made to...
Read the articleBest valved exhaust for the Mercedes-AMG A45 / A45 S W177
Which valved exhaust for a Mercedes-AMG A45 or A45 S W177? The options compared (sound, material, valves) and the Rog...
Read the articleBest valved exhaust for the BMW M2 G87
Which valved exhaust for a BMW M2 G87? The options compared (sound, material, valves) and the Rog system made to...
Read the articleExhaust rules: what changes in 2026 and 2027 (Euro 7, noise cameras, MOT)
Euro 7, new-car noise, noise cameras, MOT and vehicle inspection, and models: what really changes in 2026 and 2027 for...
Read the articleChanging your exhaust: what inspections and approvals cost in 9 countries
What the periodic inspection and the check of a modification cost after changing your exhaust, in 9 European countries: official...
Read the articleIs a cat-back exhaust legal in Ireland? What the NCT checks.
A cat-back leaves your factory cat, sensors and OBD as they are; valves closed, very close to stock, valves open,...
Read the articleSports exhaust (sportsummuti) in Estonia: what the tehnoülevaatus checks.
The sound you choose, a discreet car when it matters: what a Rog valved exhaust gives you in Estonia, how...
Read the articleSports exhaust in Latvia: tehniskā apskate and the CSDD noise limit.
The sound you choose, a discreet car when it matters: what a Rog valved exhaust gives you in Latvia, how...
Read the articleNo article matches this search.
All articles